CEV'S S10 CONVERSION KIT

 

S10 KIT

This truck was featured in

if you click on either of these pictures it will letyou see the full article and description

of the installation of our S-10 kit!

NICE JOB RANDY RICHMOND!!

 

 
This kit fits the 1982 to the present Chevy S-10. These kits include all the components to convert one of these trucks to battery power. The front and rear battery box's bolt in, they are designed for 6V deep cycle batteries.

 

S10 KIT:

 
This kit requires (24) 6V deep cycle (golf cart) batteries making a peppy 144-volt truck. Top speed is over 75 mph, range from 40 to 60 miles depending on batteries used and driving conditions.
 
 
COMPONENTS
 
9" Advance DC Motor  
9" Motor to Transmission Adapter (Retains Clutch)  
9" Motor Mount  
Controller Heat Sink and Mounting Plate  
Curtis 1231C Motor Controller  
Zivan NG3 Battery Charger  
DC/DC Converter  
Albright SW-200 Main Contactor  
400A Main Fuse and Fuse Block  
Heinemann Main Breaker with Manual Disconnect Cable  
Battery Boxes  
Battery Cables  
Battery Cable Ends, Boots, Heat Shrink, and Markers  
Link-10 with Prescaler, DC/DC, and Shunt  
30A Charger Inlet with Mounting Plate  
25Ft Marine Charging Cord  
Inertia Switch  
Heater and Relay  
Heater Box  
Power Brake Vacuum Pump Kit  
Power Brake Vacuum Pump Reservoir  
Overload Spring Kit  
Front Spring Spacers  
Control Box and Connectors (Not Wired)  
CAD Wiring Diagram and Installation Manual  
We can also provide pre-wired control boxes for a plug and drive system for an additional $1,200US.  
NOTE: this kit can be upgraded to 168volts with a Zilla controller for better performance & range! call for details!
 

E-mail
Home
Kits and Components
 
 
Copyright © 2001 Canadian Electric Vehicles Ltd.
All rights reserved. Do not duplicate or redistribute in any form.
Last updated: Dec. 2, 2006
PO BOX 616 1184 Middlegate Rd. Errington, BC V0R 1V0 Canada
TEL: (250) 954-2230, FAX: (250) 954-2235
E-mail: randy@canev.com